Troubleshooting guide
EmuDeck Controller Not Working: Diagnose Emulator Detection in Gaming Mode
Category: Handheld Emulation
You’re in Gaming Mode on your Steam Deck with EmuDeck, but when you launch an emulator, the Deck’s controls don’t respond—even though they work in Steam menus.
Check Steam Input and Controller Order
First, confirm the emulator is receiving input from the Deck’s built-in controller. In Gaming Mode, open the emulator’s shortcut, press the Steam button, go to Controller Settings, and ensure Steam Input is enabled. Next, check Controller Order: the Deck’s controls should be listed first. If another controller is listed above, reorder it. Result interpretation: if Steam Input is off or the order is wrong, the emulator may ignore the Deck’s controls entirely.
Verify Emulator Input Settings
Launch the emulator and open its input configuration. Ensure the controller is set to detect automatically or is explicitly assigned to the Deck’s controller. For example, in RetroArch, go to Settings > Input > Port 1 Controls and confirm the device is set to the Deck’s gamepad. If it’s set to keyboard or another device, change it. This is a common cause of emudeck controller not working after setup.
Run a Verification Test
Open a game in the emulator and press the D-pad or A button. If the game responds, the controller is detected. If not, exit to Gaming Mode, restart the emulator, and test again. If it still fails, try a different emulator to isolate whether the issue is emulator-specific.
Rollback and Recovery
If you changed Steam Input or controller order and want to revert, return to Controller Settings and disable Steam Input or restore the original order. No permanent changes are made unless you save them.
If these steps don’t resolve the detection issue,

Ask for help for a guided diagnosis.